You are not logged in.
Lost Password?

Register To Post

 Bottom   Previous Topic   Next Topic

Advice, flux in the LED array
Posted on: 6/30 5:31
Joined 6/30
2 Posts
If you are attempting the soldering method and accidentally get flux in the LED array, be very careful. You can take the plastic frame off by melting off the Legs from the back of the board. The LED array is beyond sensitive, I cleaned it using a Cotton swab and isopropyl alcohol, this ripped a few wires off and messed up the entire center wires. After reinstalling it, the virtual boy would not turn on because it was causing a short. So point of story, do not mess with the LED array and if you’re reading this before attempting, have the board slightly elevated so flux won’t spill in and do not use as much flux as you see in YouTube videos. Hope this helps someone.

Attach file:

jpg  image.jpg (1,688.84 KB)
15717_5efab21f03e0c.jpg 4032X3024 px

 Top   Previous Topic   Next Topic

Register To Post