You are not logged in.
Lost Password?

Register To Post

 Bottom   Previous Topic   Next Topic

Trying to 3D Print VB Stand Parts
Posted on: 2019/8/26 21:07

Joined 2019/5/24
-1 Posts
Long Time User (1 Year)
Hello everyone,

The stand that came with my virtual boy I bought a couple of months ago is in need of some new pieces. The front badge has snapped in two and the clamping piece of the stand was already snapped when I got it. While the stand holds it fairly well I still risk sending my VB flying to the floor when I play sometimes.

I know I can easily 3D print and replace the badge at the front that hold the legs. However, while I can probably design (or google) a part for the clamp I'm wondering if there is and easy way to pop out the old clamp and then put in the new piece. I can't seem to find an easy way to do this and wondering if anyone had any ideas or has replaced this piece before.

I'd rather not but a whole new stand if I can print these two pieces for a couple of bucks at most.


 Top   Previous Topic   Next Topic

Register To Post