Planet Virtual Boy

ok finished with one. only issue is its as narrow as i can gat it but it seems to be scraping against the walls but i got every other screw even the on by the eye piece.

so PLEASE SOME ONE HELP ME send me one i'll trade you a sega, nes, snes or vb game if i have to

ok i just broke the screw driver after getting one screw out of one of the deep holes. so now i really need help since i have no way to put the screw back in now .......

Why not just melt a BIC pen?

http://www.stargazette.com/blogs/genx/apbond/img/bic.jpg

i have tryed the pen method and any other kind of plastic i can melt.

its to thick to fit inside and i've tried it. trust me i am very g+ood at figuring stuff out but when i get stumped i just need some one to lend a helping hand if i have to i will pay or trade for a homemade or a non home made screw drive.

Try doing this LEFT(on the right side of the control pad), B, DOWN(on the right side of the control pad), A, UP(on the right side of the control pad). If you did this correct any healthy(read: well functioning) Virtual Boy will show a screen with one horizontal line and two separate vertical lines crossing eachother. So if the vertical and horizontal cross it's your games, if not your VB is probably out of alignment

if you read all my posts i know its a loose ribbon cable since it changed when i change the focuse.



NOW CAN SOME ONE JUST GIVE ME A GOOD LINK TO BUY A VB SCREW DRIVER THAT I DON'T NEED TO MOD OR JUST SEND ME ONE ...god


im sorry but i keep getting told to do methods that i have done and fail over and over again i will give up a bunch of snes, sega few nes and even one or 2 of my vb games just to get a good vb screw driver

http://cgi.ebay.com/4-5-MM-3-8-MM-NIN ... 2503&_trksid=p3286.c0.m14

will it fit all the way and i need proof because i am very very cheap due to my lack of income and last thing i want to do is buy it and then have it not work

edit

ok i looked that the action if it doesn't work i m going to be so pissed. but hey theres 2 bits n now i can use it on my snes, nes games without maring the case like i did with the homemade ones

Quote:


I LOVE YOU!!! ok i got the 2 bits today, so now i can open up my other Nintendo console and cartridges. now the one ment for the vb is trick it does fit but it scraps against the deep hole but i eventualy got it open, also you need to use a screw driver that only accepts a little bit of the bit, if not the its too short.


so now i just need to remove the screens and pop them into the oven so i hope doggs site is still working.

now if i get this to work i would like to buy a vb battery pack whats the standard price for one or can some one send me a spare one?... o ya i will up load a few pics of me fixing this

ok the oven method did not melt or soften the rubber at all i was afraid i would melt the screens so i took it out since the board was hot n the cables were flat so i put tape around the area like dogs site said. so i put 2 screws in it so i could go test it. popped in wario land , red alarm and seems to be fixed, i think the tape helped more then the oven method. so thanks to every one for the help and links. for the ones who helped me dog and master of puppets if you guys want i have some snes games if you guys both want a free one just cover shipping and its yours. basically a whole bunch of sports games